Search:

Their website says discontinued....Thanks

Looking for a seal replacement for my master cylinder for my 2002 conquest, Part 161-25. Checked with my local dealer and was told that the part is discontinued and there is no replacement part....

Curious if a 15hp powerfist engine from Princess auto would be big enough to run my 6x6 argo without any problems? Would it be enough power? Recommendations? TIA

Plott hound, Are you saying that you do not need the solenoid at all?

Thanks for the advice. I did not think about plugging the hole with another nut to see if that works...... Now time to go take the carb/solenoid apart again.

Just wondering if there is any way to check to see if the fuel shut off solenoid (backfire solenoid) in the carb is working properly before I go spend $140 Canadian for a new one. Fuel is good to the...

Great job on the plow and like how you set up the power angle...

Nice hunt........great vid.....

Thanks a lot...that vid was a great help......and I will get some compressed air for cleaning computer instead of using my compressor...

Just wondering if anyone has any good vids for cleaning a Kawasaki fd620 carb? I think I need to give my carb a good cleaning and just looking for some good pointers.

Thanks in advance.

Rock Doc has a great cheap idea....Willows rope and a tarp..

Maybe you could make a small frame and use chicken wire or something like that....

Checked valves and compression is now at 100psi on both heads. Why would I lose compression on both heads if I only changed head gasket on one head? please help!!!!!!!

checked valves but still low compression.....only about 100psi on both cylinders. Any more ideas??????

Just changed the head gasket on my argo and since then I have loss compression in both cylinders. Head gasket was replaced on back (firewall) head. Compression is now only 90 on back and 65 on front?...

If you remove the spark plugs and just turn the key over you will see coolant coming from the plug with the bad head gasket.

Son was out on his 4 wheeler and broke the shaft off. I had to load the bike into the back of my conquest and bring it home. No problem for the Argo to haul this 350 big bear.

Nice looking machine that I am sure will be of great benefit. However, I think there should be a canopy for winter month as this would help prevent cold injuries such as frostbite and hypothermia for...

From Whitbourne, just outside St John's.

Markings will be stamped on top f the tranny when you are looking at in the engine compartment. Also you may want to take a look at the "used buyers guide" on the home page.