Good day. I have a 97 bigfoot and I take off the heat shield off the muffler, slip my belt off to get at the filter. I do have an oil filter relocation kit for it, just haven't got it on yet. ...
Type: Posts; User: BF6X6
Good day. I have a 97 bigfoot and I take off the heat shield off the muffler, slip my belt off to get at the filter. I do have an oil filter relocation kit for it, just haven't got it on yet. ...
Curious about which bearings you find to be the most durable, long lasting bearings? Have two rear outer bearings that are in need of replacement. Any expert advice on what you or anyone find to be...
In response to your statement, I agree with the fact that people do get busy with work,and life outside work. Happens with myself a lot. Different forums I'm on have times that seems like they dry...
http://http://www.6x6world.com/gallery/6x6-around-the-world/p29310-20220614-152819.html
I like them. Nicely done sir.
Breadstain there's a person who lives a few streets away from me who has roughly 2500hrs on his Argo. Its Early,maybe mid 90's. Works great. I myself have a 97 bigfoot that has almost at 700hrs...
Went out for a long cruise. 50kms out then back and no problems. Running well. Now if I can get the materials to build a set of tracks without costing a small fortune I'll be happy. For now just...
I've heard that they are good motors except for heat. Not much room for heat dissipation. So far the 18 is not running to hot. But haven't been out for a long haul yet. Maybe tomorrow I'll give it...
That I did not intend to. It ended up like that and I haven't been able to correct it.
Well the engine is in. Time for a test drive tomorrow. Starting better, smother. I'll see how it does tomorrow, with response, and running temps. Damn I love these machines.
Sorry I didn't mention what did. My apologies.
When apart, it got rings, valves, valve springs with the hardware, valve seals, bearing, bushing, all the seals, gaskets, and for desert the carb...
Mr Swenson good day to you. The motor is an 18hp vanguard. Due to the gremlin, I dismantled it to see if there was any unforseen damage. All in all there wasn't much. The engine had 598hrs on it...
http://http://www.6x6world.com/gallery/data/642/thumbs/20220614_152819.JPGParts arrived yesterday to rebuild the engine in my bigfoot. The nasty little gremlin did a bit of damage. But caught it in...
What is the engine not doing? Running rough? Poor power?
You could try Shell S2000 Red grease. It's says water resistant but I find it to be more waterproof. It stays put on my chain's and sprockets. Protects against Wear very well. Another I started...
Finally able to login. This is awesome. Thanks definitely for the help getting back. This site makes long nights at work when there's downtime go smoothly.
I have a 97 bigfoot in which the brake cooling fan was shot. I'm going to use a boat bilge fan, hooked up to switch then connect the ducting . 3" in 3" out. Also putting one in the air duct to...
Did you find the gremlin causing the problem
Would you have any pictures of the install? Interested in getting my Bigfoot a bit cooler. Did you mount as to blow through the engine shrouds?
Quick check is to put power to the wire going from the key switch to the starter solenoid. Unhook it from the switch, turn on your key,then put power to the wire going to the starter solenoid if it...