Search:

If and only if you think no mechanical resolutions are needed, I would let air out of all tires on the oppsite side of the pull until it stops pulling. If you are running flats on the left, and...

I have various parts for sale.

Best time for me has always been just before duck season gets good and hot. (early december) Tax time is never bad either. I always buy in the late summer.

Jumper the starter solonoid. I'd use pliers with rubber grips. It'll scare the crap out of ya, but id bet this is your issue.

So as usual, replacement argo parts are impossible to find on a saturday afternoon in West Tennessee. Now I'm gonna miss out on duck hunting in the AM because of a stupid broken throttle cable. ...

Had the same thing happen. I loaded my gaskets up with bluegasket maker just incase. No more puking!

Here's a total install kit for 41 bucks. Trust me, you don't want the float switch, the water will need to be 3 or 4 inches deep in your argo before it will float. By then, your close to chains...

I made the mistake of taking my first Bigfoot into an extended deep water trip without a bilge. Didn't sink her, but had a wild time getting back, since the belt got wet. After that day I installed...

That's an awesome story. I envy you much after reading this story. I wish I had the balls to uproot my family from Tennessee and move somewhere similar to where you are. My young family is very...

because your valves need adjusted.

As for you bogging issue............If you've got a vanguard, and she has any age, it is a known issue. It won't hurt to take it apart and clean the bejesus out of the carb, but If anything it's...

WFO's max looks AWESOME with that cage, and wheels tires package!! Might be the best looking AATV i've seen. Is that a honda pilot on the trailer? I haven't seen one of those in 20 years

This is my second Argo, and it's way faster than my first one. (04 bigfoot). Don't remember what trans the 04 had, but it was more suited to my liking. I could turn from a dead stop with a load in...

To my suprise my trans is labled 27530 HU

Many of you know how loud the trans can be in some earlier models of Argos. Specificly 99-03 i think.

On my argo, High gear speed is basicly useless. It's way to fast for my means of...

.............while reassembling? I didn't see Rock Doctor do this in his vid. Is it ok to float them? Should I just remove the set screws if not?

i'm doing a bearing and seal swap on my 01 Bigfoot with 465hrs, and i'm contemplating an engine rebuild. The engine is right there just asking to be pulled. I have all axles out, and i'm idle...

I think magizines have dropped considerably since the internet boom.. However, Jim Shocky's Outdoors TV Show is sponsored by Argo. (outdoor channel) He rides his 8x8 in several episodes.

RD,

I say go get it, so we can see more Vids of you fixing it!

Just for future searching reference.................I broke 3 of the 4 gear pullers while standing on them to force the bearings out. So, I was down to my last one when it hit me. Instead of me...