Heres how I ended up doing the inner bearings. I meachined the square tubing to fit the channel tight, then spot welded it from the back side.
Heres how I ended up doing the inner bearings. I meachined the square tubing to fit the channel tight, then spot welded it from the back side.
Works for me, maybe literally.
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs.
I used the bushing rod for lining everything up.
Where you find those hubs??? those are g&g hubs correct??
Hubs?
Dave, there are a ton of places out there that say the G&G sprocket hubs are out of stock, but Shoup says they have them in stock. Not sure exactly that you'll be getting G&G, but I did when I order them a few years back.Originally Posted by dave phelps
Check it out.
These are for the W series (1-5/8" ID sprocket):
https://www.shoupparts.com/W11406P-Spline-Bore-Hub
These are for the X series (2" ID sprocket):
https://www.shoupparts.com/X11406P-Spline-Bore-Hub
Ya the 5 bolt hubs??
WOW!! Thanks Mike,I drive past this place every darn day and never even gave it a thought!! now I owe ya a beer or two!!
Thanks again
Dave
The amount of people who owe Dave beers, he is going to be an alcoholic if he isn't one already!
"Racing is life. Anything that happens before or after is just waiting."
Bahahahahaha!!!
Posting Permissions
Reply With Quote
