6x6 World

Max axle upgrade

monkstr6100 — Fri, 15 Jul 2016 22:54:38 +0000

by: monkstr6100

Description: Design with sleeve installed.

Max axle upgrade

monkstr6100 — Fri, 15 Jul 2016 22:54:35 +0000

by: monkstr6100

Description: Here is another design that I first came up with before sleeving them. Would work well I think, and only need 1/4" flat stock so may be easier for some to come by.

Max axle upgrade

monkstr6100 — Fri, 15 Jul 2016 02:07:52 +0000

by: monkstr6100

Description: I used 1-1/4" sch 80 seamless pipe to outer sleeve my max II axle shafts and then added gussets as well. Note that I did NOT weld the sleeve to the axle on the inboard side. This would weaken the shaft and the sleeve to axle is a pressed fit already so not needed. Hope this helps.

Max axle upgrade

monkstr6100 — Fri, 15 Jul 2016 02:07:47 +0000