Headllight Hole Diameter?

[turvuren]

I think I can measure one tomorrow for you. Do you think the poly body machine is the same?

[jpswift1]

No problem. Is there anyone else that might have an Attex with the headlights out of it that could measure the diameter of the hole in the body for me?

[nate52]

yea no problem. wish i could have helped. but hopefully someone chimes in with the information you need.

nate

[jpswift1]

Nate. thank you so much for doing that, but I totally forgot to mention that I needed a measurement of a machine without the chrome headlight bezels. The machines, both Thunderchief and Chiefs had chrome bezels in 1973, had chrome bezels and their opening is smaller than machines that had rubber grommet mounted headlights. Thank you very much for checking though, it is appreciated.

[nate52]

hey jp, i just got done pullin my headlight and puttin it back in. the hole in the body for my headlights is 4 1/4" and the headlights i have are the sylvania 4000 and my machine has the chrome bezels. don't know if this helps much, but you should be able to cross reference the part number for the headlights.

[nate52]

i just put my headlights in the other day, but i can get the measurement for you by the end of the day.

nate

[jpswift1]

Does anyone have an Attex with the headlights out of it? I need to know what diameter of the hole is where the headlight goes so I can cut them out on my 440 Thunderchief racer. Thanks!