i just did the firewall and most of the engine compartment in a sound insulation called B-Quiet ultimate. seems to have helped. its reasonably priced compared to dynamatt and almost as good. they say...
Type: Posts; User: dromas
i just did the firewall and most of the engine compartment in a sound insulation called B-Quiet ultimate. seems to have helped. its reasonably priced compared to dynamatt and almost as good. they say...
I added large computer fans in my hood scoop to suck out some of the hot air works quite well
What engine do you have Lh630-775 thermostat closes at 175 and opens at 195 the over temp safety kill switch is at 255*F
Ill start with a couple obvious ones. Rad fan and water pump are working? Proper antifreeze mixture?
With those pressures I have never walked out of a track or blew a bead. I would assume those pressures are recommended for proper tensioning of the track and easier turning with the higher pressure...
What pressure are you running in your tires with the tracks on..should be 5psi front,7 psi for both middle , 6 psi rear
rigid industries are a nice led option very bright and durable but you will pay for them i would recommened dually D2s
hey with rubber tracks on its 26.5" from the floor to the top of the tracks or about 33.5" from floor to the low part of the body this low section is about 18 - 19 " wide beyond the forward 12" is...
hey sawbuck i am in dryden ontario if you are close enough to drive here you are welcome to come put a few hours on my 2011 750 hdi currently on rubber tracks. i can get some exact measurements for...
the optima for my 2011 HDI would be a yellow top D34 should be the same i would imagin
Front Mounted Cargo Basket for Argo Avenger - Frontier
over priced for what it is but might give you a idea where to start building
you are correct they are on backwards
you would probally get more help if your post had more info. like some pics of how you have them setup/attached to the conquest and information on what a lenco outboard is. i did some searching and...
i got curious after this post and decided to go check the torque on mine the forward 3 bolts on the front bearing extensions were not at the required torque with the bottom bolts be the worst...
good to hear glad it worked out for you.. this sounds like a step in the right direction for argos in ontario
i have heard of one guy on here that had a problem. but i think he had a problem because he didnt follow the manufactures maintnanace schedule. mine says to retorque after the first 8 hours and then...
i would estimate 11000-12000 for the avenger before accessories add tracks top heater etc probally more like 14-16.
rebuild asumming sprockets also need to be changed and you buy argo part #...
also make sure you have battery voltage at the B+ terminal (the one that does not go to the stator) on the regulator plug with it disconnected engine not running
Did you just get this machine and the charging system is not working? if so i would find a wiring diagram and make sure everything is connected and connected properly. check the connections for...
(807) 223-7333 try that not toll free but will work for sure