Forum: Max ATVs

Hello. I've noticed a difference in the laterals. Some are straight up and some are bent to the left side. I figure the "newer" models are bent but...

2001 Max IV primary chains have about 2 inches of play when pushed down on. How much play (if any) should there be?

im trying to see if 22x12.50x8 super swamper tires will fit on my maxII my max has the outside muffler on it

Hi I was wondering if someone could tell me what size drive belt I should use on my RIM with the g50b engine. Thanks

I may have had what could be my last ride in Southern California. Other than melting some plastic by the exhaust outlet, a still leaking t-20(even...

Is there anywhere online that you can order Max parts directly. Richards is OK but its a little dated that every order needs to be called in. I...

I recently just purchased a 2006 max 2. I am starting to get it ready for the upcoming winter months. I am looking for information on which...

Hi, I have a max II with 18Hp B&S V I looked the drive belt up and it should be 30mm 1 3/16" Mine is worn to 26mm just over an inch Is it time...

I have just acquired an older Max 11. This is one machine that I have never driven before. I have read the manual posted for the T20, so I understand...

I found this part on Max6X6 and I have no clue what it is, I completely disassembled my MaxII and did not see anything like this on mine. 15300...

Can this be done? If so do they bolt in? If not, can mine be easily bent? I'm just toying with the idea. It's clumsy driving my IV offset with a...

Is it normal to have a 1/8 play forward and backwards in a splined axle and sprocket,or are they machined with no movement at all ,

I need a replace the fuel tank in my max2 any ideas.....

Installing a HF 3,000# winch. Installed the fabricated winch mount with backing plate and am going to mount the wiring block to the backing plate....

Hey guys,] Today I called my chain supplier to order some Diamond chain for my recently purchased used MAX ll. He only had 10' left. I needed enough...

My max 2 has grade 5 bolts connecting the sprockets to the axles. Is this sufficient ? The hustler i rebuilt in 02 had case hardend bolts, #50 drive...

I have the serial, how can I tell the age?

I'm upgrading my 1996 max 2 engine from a briggs 14hp to 23hp Briggs I'm looking for a new belt and need to know the size of the belt and clutch...

Went up to Maine with the junkman on 4-28-2013. Brought both our Max 2s. I haven't tried editing as i'm computer illiterate. Maybe next week. Anyways...