thejunkman
Master Mudder

You run aquatorques with no air. They tape 24" at 0psi. They do not contact each other. We fit them with 3"when spacers but I can't remember if that is too much or not. Depending on your body you might need to heat and stretch it just above a tire or two.

Keith.

Hey tom did u get a new number tried texting u and it wont go through. shoot me a text if u did. chris

I tryed to look up my history and didnt see my post the link i got mine from but I know it was off of ebay they were out of CA but I am not sure which company.

5x4.5 Inch Bolt Pattern spacers | eBay

Hey tom thanks again for the throttle lever and cable. its like a whole new machine im going to have to get used to it all over again

Tommy once you get a set of Adair tracks you,ll be unstoppable. I have not been stopped in any bad mud hole and at any atv park that I,ve been too.

I have not gotten the chance to even try the Aqua tires out yet because of the prolonged and intense heat that we've had where we like to ride at. The heat has evaporated all of the water out the mud holes. Unless we get some rain this fall it might not be until the spring of 2012 before I get to test them out.

pm sent

im from augusta georgia and im not sure what max it was i just had a message from u saying u had a max for sale and i was responding to you. and ok where r u located at because im sure its been taking care of and 3600 isnt that bad

well i post a thread about anyone that had a max for sale and u sent me one about a max for 3000 and i finally looked through my messages maybe that is the max that i was talking about im not sure

The calipers that i used on my Max IV came off of a Yamaha warrior it was easy to mod to the Max ...but the you will need handle bars in the max so that the brake fluid don't leak out of the brake resivor .All so the rotors that you see in the pics I put them in it to ,,the max that I have had drums on before I switched it over ,,I can say when they are set up right they will stop the max in its tracks .I think you can use other calipers besides the ones that I used ,,just get in there and play with it,, you can find some to fit .