help with argo pulling to the right

[gibba]

Hey guys thanks as always to you all for your comments, firstly ratman and evil, i have shimmed my calipers out so they are centred on the discs as should be, how else can i adjust them? yeah atvrider i have checked pressures and they are fine, once again thanks for your imput guys....

[Rock Doctor]

Its driving me crazy, i was riding around in the argo today in the snow, and after about ten minutes its started pulling to the right again. I have replaced all bearings, chains. tyres, brake pads and countless other bits an bobs including chassis! Does this sound like a tranny problem?

Did you check the output shaft bearings on the trans?

[gibba]

Hi rockdoctor, no i havnt, could this be the problem thats been driving me crazy!! how do i check these without a serious op or do i need to go in and investigate?

[Rock Doctor]

Hi rockdoctor, no i havnt, could this be the problem thats been driving me crazy!! how do i check these without a serious op or do i need to go in and investigate?

Not sure, but there does seem to be something..............not quite right with your machine. Sounds like you have checked everything suggested by the members here.

Loosen off the Trans mount bolts
Slack off the idler chain tension adjustment bolts
Once you get some slack in the idler chains, try to lift/wiggle your output shafts. If you have any movement, you might want to investigate further.

RD