rotors question

[chapy]

Can the rotors be turned on argos? My left side feels like it is warped a little. It seem to grab release grab release grab release when turning.

[Rock Doctor]

I don't think so. I vaguely remember discussing this a long time ago, and was told that it could not be done.
It may just have been that there was no place local to me that could do it.

RD

[chapy]

That's what I am afraid of. I think turning them would make it to thin

[rodp]

It's scrap anyway so what's to lose, chuck it in the lathe and try it.

[msafi65]

I have an old output shaft to hold them but they don't turn good usually hard spots. I have used a tool post grinder but new can be had for about $120 each and you get a known good one. I usually just remove the rust and call it good if they aren't jerky.

[wedge]

Some engine shops with a fly wheel grinde may be able to surfice them. Turning one is not the way to get a warp or hot spot out. You need to have them Surface ground like a flywheel .