Announcement

Collapse
No announcement yet.

New 2015 Argo 750 hdi

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Don't mind that, hook up jumper/start and follow the rest.
    sigpic

    My new beer holder spilled some on the trails - in it's hair and down it's throat.
    Joe Camel never does that.

    Advice is free, it's the application that costs.

    Comment


    • #17
      Are you sure? haha Makes it sound like its pretty important in manual that you remove any type of load.
      2015 argo camo 750hdi- rubber tracks, bilage pump, rear hand rails, winch, brush guard, alternator, heater, full soft cab and windsheild.

      Comment


      • #18
        If your machine has an alt. you can pull wire/s from it if concerned as belt gonna suck hp and not power if wires are off, I never have but easy enough.
        sigpic

        My new beer holder spilled some on the trails - in it's hair and down it's throat.
        Joe Camel never does that.

        Advice is free, it's the application that costs.

        Comment


        • #19
          Are you allowing the fuel pump to cycle a few times before turning the engine over?

          Comment


          • #20
            mine was doing this to but its a 2010. I found poor connections to one coil from the ECM, took abit of looking and the pin out to figure it out.

            Comment

            Working...
            X