Need to replace the rear spark plug wire

[Rck90]

During a backwoods drive returning from a mens retreat, my argo starting losing power. I stopped to Check it out and found the rear spark plug was loose so I pulled on the plug wire so I could tighten the plug down..well the end of the plug came off in my hand and fell down into the black hole and I would like to know if the wire can be replaced easily?
Anyone with a step by step instruction for a 1998 conquest.
Thanks in advance for the info!

[ARGOJIM]

If you can find the cap (ass/u/me ing you lost the cap) it will screw right back in place.

[Rck90]

Jim, My post maybe misleading, it was the cap/plug on the end of the spark plug wire that is gone. I need to remove and replace the whole wire or if possible just the end that plugs into the spark plug.

[ARGOJIM]

The cap is replaceable, if you can find it under the powerpack you could just screw it back on as the cap has a threaded stud that screws into the wire core. A small ,1/4", nip of the wire may be necessary.

[Rck90]

Really? I'll make greater efforts on locating that little SOG! Thanks Jim..!

[Rck90]

I found it. When I removed the "new champion spark plug it was toast, the plugs rubber had melted a little. I put it back on and it runs fine. Thanks again Jim it was so simple!

[dale7637]

I just had this issue on my avenger. I now pack a spare plug end with me. If the need arises, I can pop a new one on in a second.