Tweet
[url=http://www.6x6world.com/gallery/tb-2fkb-argo/p26407-img-20161003-214310.html]
[/IMG]
11 "wide at the top,tapered down to 3.5" wide bottom and (section between bends 4") 1/4" flat plate the 2 bends look to add up to 90 deg
-
[url=http://www.6x6world.com/gallery/tb-2fkb-argo/p26407-img-20161003-214310.html][/IMG]
11 "wide at the top,tapered down to 3.5" wide bottom and (section between bends 4") 1/4" flat plate the 2 bends look to add up to 90 degLast edited by Ford4x4j; 10-03-2016, 10:13 PM. -
so from the bottom on that plate in side that is roughly 4 inches wide, how far up does it go until it starts to get an angle in it? and is it just one angle and then it just goes up or is two angles? if you can get me the angle the metal is bent?Comment
-
also how long is the plate do u think? forget the angles i didnt read your post lolComment
-
Approx 14" bottom to top 4", 4", 6" im not sure why one 90deg wouldnt fit but you would have to put a square in there to see that .there is also a piece of angle top where it wraps over the hoop itsselfComment
-
Hey sry Curtis i didnt know you asked me for anything till just now. It seems you are in good hands now tho so i dont feel so bad..
if you ever need something from me, send me a pm so i am notified as soon as i log in.
"I've yet to encounter a problem that cannot be solved with the right mixture of whiskey and weaponry"
:ME....
" From my cold dead hands"
:Charlton Heston...Comment
-
ho dont worry about it kris!! and thanks ford 4 by 4!Comment
-
i have a cardboard one made but i need to know the angles! could you get them for me??
Comment
-
I'll try to remember protractor from work tomorrow did you try puting a square in to see if 1 90 deg bend would fit?)Comment
-
id rather just have the two angles.Comment
-
The bottom bend is 120 deg inside and the 11 " bend is 160deg and no a single bend would contact on the cornerbut the combined bends you looking for approx100 deg insideComment
-
when you say inside do you mean the inside numberas on the protractor?Comment
-
Inside the bend ,as opposed to from zero .Comment
-
How thick is this winch plate?Comment
-
Does the top of the winch plate touch the good metal frame??? And how does the little angle Iron work to hole the hoop on plate?Comment
-
finally got the winch on and mounted,thanks to my girlfreinds father for the winch mount.... done an awesome job on it!! the winch is on there now just didnt get a pic my camera diedComment
Comment