This past weekend I changed the 4 long chains on the rear axles. Next set will be the shorter chains on the 4 front axles.
The excessive slack seems to be gone now.
I checked the drive belt and it looks like it is pretty worn out. According to my manual it should be replaced if it is less than 1 5/16" wide. I measure it out at only 1 1/16".

Can someone verify that the minimum spec. of 1 5/16" is correct for my machine and a good source for a new belt?
Would this thinner belt affect the torque from the machine? Any other symptoms it would cause?
Thanks and sorry for all the newbie questions.
The excessive slack seems to be gone now.
I checked the drive belt and it looks like it is pretty worn out. According to my manual it should be replaced if it is less than 1 5/16" wide. I measure it out at only 1 1/16".

Can someone verify that the minimum spec. of 1 5/16" is correct for my machine and a good source for a new belt?
Would this thinner belt affect the torque from the machine? Any other symptoms it would cause?
Thanks and sorry for all the newbie questions.
Comment