Argo Hood Vents

[Charliemaker]

Morning Folks

I am looking to make some improvements to the venting/screening to my Argo Magnum Hood.

Attached are photos of what I have including an aluminum vent/screen that was added to keep branches and crap out. I however feel this limits airflow and am looking to replace these with something else.

Please share ideas of what you have done with your machines.

Cheers!

Argo Hood 1.jpg

Argo Hood 2.jpg

Argo Hood 3.jpg

[trevorakm1]

I used the 1/4" square mesh at the depot. I cut to fit and always mount underneath the plastic. I also paint hardware either black or green, Krylon make a camo spray paint very close match to Argo green. I like to screen any openings I can get at to prevent leaf litter and such getting into the hull. I minimize the crap at the bottom of the hull to prevent any extra wear on the drive trains.