Reverse Lever

[4g63tmirage]

Making sure I have all that is needed to put the st300d back togrther, and I noticed that there is no rod for the reversr lever on the baker-hill 7000 trans. Have been looking at/for some photos that show this rod and it's location...

thanks,
scot

[LarryW]

The rod went from the lever and through a hole in the floor pan under the seat. Im not sure if I have any pictures of it specifically but there might be one somewhere in my gallery. It was nothing fancy. Just a rod with flat end with a hole for the pin at the end where the lever is connected. Other end is threaded and I just have a nylon locking nut on it. Im sure there was suppose to be a knob but I never seen one. If you make one, make one that you can disconnect easily with a pin on the lever side because you have to take it out to remove the floor pan. I have seen some people make one with a heavy control cable which is also an option.

[4g63tmirage]

thanks again, Larry

scot