Radius bends for roll bars

[x.l.r.8]

Being in the owner of 'other aatvs', I am building a simple roll bar for them. The Bazoo will be pretty much the kinf og thing you would find on a Jeep. The Jiger will be a need far less agressive bends. I wondered if anyone has a site that they get bends to make up roll bars from. I'm going to check out the usual suspects like Summit and Jegs, but being thousands of miles away from my old haunts in the UK I'm at a loss for this stuff.

[Mike]

You can pick up a cheap bender for about $100 USD that will do the job if you feel like doing it yourself. Here's a great article on tube bending and how to get the proper radius that you want while keeping everything level if you decide to go that route:

Tube Bending 101

[jpswift1]

Talk to forum member hydromike about building roll cages. He did my cage for my Attex racer. He does good work and might be able to help you out.