Hustler sprockets????

[mitwood]

I ave a 80's model Hustler w/a 440 Kohler motor. Where do I find the sprockets for it?

[duckhunt81]

Do you have the sprockets but they are just worn out? If that is the case I would do some shopping around at places like TSC or a bearing supply shop to find a replacement sprocket. Then take them to a machine shop and have them replaced and welded. This is what i had done just a few months ago on my middle sprockets, mine was worn on the one that the T-20 comes off of. If you have nothing to start with Richard's Relics the places for you. I did call Richard during my quest, I seemed to recall $150 per axle on the middle sprockets
BTW - it helps to have a friend or two that are machinist, a case of beer is cheaper than the shop rates.

[Amphiman1]

hustler sprockets

i have a few decent ones for about 1/2 of a dealer...

[brushcutter]

Richard gets $50 per sprocket, you can get them cheaper elswhere, but then you are faced with the cost of machine work/welding. Check your local shops to see what they would charge to do this before you go buying anything. As Duckhunt says beerbucks are easier if you have a buddy. Otherwise you will want to know which of these other options are actually cheaper, the shops in my area run from $40 to $60 per hour. So your cost per sprocket could be even higher, depending on the cost per individual sprocket added to the price of having the work done to turn off the old and then weld the new in it's place.

[Amphiman1]

hustler pieces....

i may have 2-3 more hustlers coming in for parts?

[mitwood]

thanks for the info. sorry it took so long to reply. I found a broke x-bar under my trans. so i think this is causing majority of my problems. I guess i will tackle one thing at a time.

[kidkenn]

i am in need of some sprockets

i may have 2-3 more hustlers coming in for parts?

i am looking for some sprockets for my hustler let me know if you can help i can give you specs richard relics cant help me thanks

[ARGOJIM]

Try member racerone3, he just did an Apache Gear conversion so he may still have the stock ones.

[kidkenn]

i have a few decent ones for about 1/2 of a dealer...

i need 2 three sprocket hubs any help

[amphibious drew]

i need 2 three sprocket hubs any help

Amphiman is not on here anymore, not do I remember seeing any hustlers last I was over there. If you get me the tooth count, I have a set of hustler sprockets laying around I could sell.

[b.seas]

Is that an Amphiman tooth count or a sprocket tooth count? haha!

[ARGOJIM]

[kidkenn]

thanks for getting back on hustler 3 sprokets the 2 smaller sprockets have 26 teeth the larger one has 30 my main concern is the 2 that are 26 as you know run to the front and rear axles the third runs off the t 20 as long as they are a match on 26 teeth mine are wiped out i just got this thing and i am rebuilding this thing and had a chance to drive it and love this thing its a blast in the sand dunes where i live and are unheard of in calif thanks again