Hustler 945 wont go-newbie here....

[johnnyo]

Ok this hustler just started getting me frustrated, need some help...finally got my 945 hustler going again, went to turn in the sand and heard a grinding noise and then no movement( without alot of grinding and bumping)... ok...stopped...pulled back and saw that there is along skinny bracket that is attached to the transmission going back to engine along the right side.. where a bolt is attached to a rectangle piece of metal which looks like it slides into a holder next to the engine... basically like a brace...now not sure what this is called but every time i go foward or reverse the transmission is jumping and the huslter doesn't move without any real purpose and my ability to turn is totally gone... any help or good advice... all the chains are attached and aligned, no mods have been made to hustler just couldn't find a picture of where the bracket goes and didn't see another one like it on the other side... john

[Zfish]

Post pictures of what you broke sounds like the Franny mount but I'm a newbie my self

[Mike]

Are the bolts or nuts on the transmission mounts tight?

[Zfish]

that should have been tranny mount! not franny lmao! Stupid smart phones!

[highrollinmopars]

Hey Johnnyo where are you located? If you where close im sure a member on here would be glad to come to and help you get going again.

[johnnyo]

it looks like a tranny mount......i'm in live oak florida...in between jax and tallahassee....