Just ordered bearings and T-20 stuff

[boncrshr]

Big thanks to JPSwift for the outer bearing hookup. Ordered a set of triple sealed outer bearings that were very reasonable from Buffalo Bearing. If you guys ever need them, this would be the place to shop.

Also ordered a T-20 seal kit and red clutch spring from Recreatives, and thanks to Meinfeld, ordered a smaller belt from Dayco. So now it will be time to stop spending money and get my hands dirty. But these parts were all pretty cheap, a lot of bang for the buck. Now I will just finish my rack and be ready for June 3rd!

[Meinfield]

Sounds cool! Guess you will be ready for those ducks!
Are you working on a gun rack? I thought about building a dual gun rack and a storage box for the rear deck. There is actually a lot of room back there for storage. Check out these links:

http://www.route6x6.com/readersrestoationsimages/readersrestorationimages/rr3.jpg

http://www.route6x6.com/photogallery/images/pg261.jpg

Chris

[boncrshr]

Hey Mein,

The rack is definitely in the planning stages now. I am going to put a flat deck that extends from the back of the driver's seat to the back of the Hustler. With backrests facing rearward, so that people can ride on the deck if need be. Also, will have a light rollcage with storage on top, and a flip-up compartment where the back seat used to be for dry storage. Muffler will be routed outside the body.....

You going to that June 3rd ride?

[Meinfield]

Where is the ride? Must have missed that post...

[boncrshr]

http://www.6x6world.com/forums/trail-rides-clubs-events/2092-marengo-swamp-run.html

Near Shreveport....shouldn't be too terribly far for you?

[Meinfield]

Oh yea, I might have to make that!!