Max IV: Rear seat removed with cargo box in it's place?

[djgeiman]

Rusty,
I never got your email try me again djgeiman@qis.net

[Rusty-Gunn]

Digeiman... E-mail sent. I seen two pics of your cargo box in the gallery. Thank you.
I do have an aluminum floor plate simular to yours. I got my rear bench out and removed the original plastic plste, then put in the aluminum plate. I carried an insane cargo load piled up higher than the Max to the camp site this weekend. Three trips out, two coming back. Other atvs hauled stuff too. Twenty teens from our church youth group attended. We had a wonderful time ( excet for the rain).
I need to improve the cargo space. I intend to add a back plate. Mine goes up about ten inches. This would allow for engine venting provuded it isn't up against the hood cover.

[akcrawler]

Rusty,
It sounds like you need a trailer. I know they can sometimes cause more problems than they fix, but you can haul a lot in them if the trail isn't too bad.

[Rusty-Gunn]

Rusty,
It sounds like you need a trailer. I know they can sometimes cause more problems than they fix, but you can haul a lot in them if the trail isn't too bad.

My brother has a nice atv trailer I can use. Unfortunately the front axle bearings need replacing and I was not able to use it. Thanks for the suggestion though.
I think a little improvement to the one Eric made for mine is the way to go. All it needs is a longer back, with venting behind it.