Tweet
This weekend I should be ready to install throttle and choke cables, fuel line, and wiring.
I am looking hopefully for photos of typical routing.
My older Max II wiring was a nightmare, two sets of accessory lights, a bilge pump, a winch, and a 2nd battery, wires were everywhere. Whoever wired it believed in heavy doses of twist locks and electrical tape. If wires were too long they were doubled, tripled or more over then zip tied and taped, choke cable was gone, and fuel tank was a plastic auxiliary boat tank sitting on engine cover so fuel line was ran through upper body vent slots.
The newer Max II has the proper fuel tank but had no wiring, cables or lines on it when I got it. I've put too much effort into this build to not have things right, clean and neat.
Any help greatly appreciated.
I am looking hopefully for photos of typical routing.
My older Max II wiring was a nightmare, two sets of accessory lights, a bilge pump, a winch, and a 2nd battery, wires were everywhere. Whoever wired it believed in heavy doses of twist locks and electrical tape. If wires were too long they were doubled, tripled or more over then zip tied and taped, choke cable was gone, and fuel tank was a plastic auxiliary boat tank sitting on engine cover so fuel line was ran through upper body vent slots.
The newer Max II has the proper fuel tank but had no wiring, cables or lines on it when I got it. I've put too much effort into this build to not have things right, clean and neat.
Any help greatly appreciated.
Comment