Max 11 Questions

[OUTLAW]

I Have A Max 11 That Came With A 14hp, I Swapped Eng. To 23 Hp. Like Ya'll Said,it Was An Easy Swap.do You Guys Know Where I Can Get An Exhaust Syst.to Fit ?23 Hp Vanguard,i Pieced Stuff Together,don't Realy Care For What I Got.(combined Go-devil Exhaust & Max Exhaust Together)
Also,how Do I Work Those Chain Tensioners?is There A Trick To It? I Looked At It,thats All,she Don't Slip,but Looks Like May Have Some Slack. As I've Read While Searching Here,raise Tires Off The Ground,how Do You Slide Them Up Or Down?
One More Thing,how Much And What Kind Of Oil For Trans.?is There A Drainplug Or Do I Pump It Out?
Just A Little Preventive Maint.
What Would I Do Without This Site? I Don't Ask Many Questions Because Theyre All Already Answered.thanx!!!!!!!!!!!!!

[rdr]

I Have A Max 11 That Came With A 14hp, I Swapped Eng. To 23 Hp. Like Ya'll Said,it Was An Easy Swap.do You Guys Know Where I Can Get An Exhaust Syst.to Fit ?23 Hp Vanguard,i Pieced Stuff Together,don't Realy Care For What I Got.(combined Go-devil Exhaust & Max Exhaust Together)
Also,how Do I Work Those Chain Tensioners?is There A Trick To It? I Looked At It,thats All,she Don't Slip,but Looks Like May Have Some Slack. As I've Read While Searching Here,raise Tires Off The Ground,how Do You Slide THE TENSIONERS Up Or Down?
One More Thing,how Much And What Kind Of Oil For Trans.?is There A Drainplug Or Do I Pump It Out?
Just A Little Preventive Maint.
What Would I Do Without This Site? I Don't Ask Many Questions Because Theyre All Already Answered.thanx!!!!!!!!!!!!!

can't help on the exhaust try a 18 briggs chain ten slide down to tighten the chain typ f for you tranny with the chev limted slip . onily fill to bottom hole in the t 20 robbie

[Mike]

Have you called Recreative Industries for the exhaust to see how much it would be?

The front chain tensioners pull up and the back ones push down. You can usually do them by hand however sometimes you have to use a little force. There is an article in the how-to section with a lot of pics of the tensioners: http://www.6x6world.com/forums/gener...placement.html


For the T20 use Dexron III (ATF). It only holds one quart. There are two plugs. You remove the both plugs. Then pour the fluid in the top hole until it starts coming out of the bottom hole. Again, it should only take one quart to do this.

[Roger S]

You'll have to fab some of the exhaust, as max never used the 23 briggs which the heads are a little different than the 14-18 which max did use.

[philipatmaxfour]

filling t-20

can't help on the exhaust try a 18 briggs chain ten slide down to tighten the chain typ f for you tranny with the chev limted slip . onily fill to bottom hole in the t 20 robbie

My 2003 manual for Max IV says same as Robbie: Drain the T-20 or pump out, Add 28 ounces of Type F auto tranny fluid plus 4 oz. of GM limited slip diff, fluid== 1qt. Good to go. Plug with vent goes inti TOP hole.

[Mike]

You'll have to fab some of the exhaust, as max never used the 23 briggs which the heads are a little different than the 14-18 which max did use.

My fault, I was thinking of the 23hp Kohler.