New member - Used Max II

[katoom08]

Hello all. Had an Argo several years ago. Just picked up a used Max. Previous owner was a nice guy but not much of a maintainer. This site has been very helpful so far however, I do have a few questions. Are there zerks somewhere on the center inside bearings like on the front and back? If so how do you get to them? Is there a zerk on the rear bearing inside left? Just two more for now... Is there supposed to be some type of seal around the braided exhaust where it passes through the tub? It looks like it will take on water there. It looks as if the exhaust will be submerged when in the water. Does this work well? Sorry for the barrage.

[mirrocraft]

hello im not as experiance as someothers here but i have a max II and have completely took it apart just to figure it out they have the grease fitting on the out side of the unit behind the tires at all wheelbearings . my max sits high enuff out of the water the muffle stays out of the water no water coming in on mine back to grease fitting i 90% grease tube will get you to them with out removing tire but a pain just as easy to take off tire and grease this way you can clean all the crap that has wrapped around outside axles over time hope im of some help

[katoom08]

Thanks Mirrocraft. All advice helps. Changed Trans Fluid today. Not an easy task but good for 50 hrs now. I am sure it had never been done before. I attempted to take one of the wheels off today and could not break the lugs. I don't think they have ever been off before. I need to get a impact wrench. The project continues!!

[rdr]

there are greese zerks at all outside tires and zerks on the inside bearings to doint for get them rex is making the outside fland with 90's deg zerks now one on the center will help wounderfuly .i put all my zerks at the bottom of the axel makes greeseing munch easyer copper rtv selent around the exhasut will take care of any water . robbie

[argohunter]

Not trying to be a smart donkey but here are my answers

Hello all. Had an Argo several years ago. Just picked up a used Max. Previous owner was a nice guy but not much of a maintainer. This site has been very helpful so far however, I do have a few questions. Are there zerks somewhere on the center inside bearings like on the front and back? Yes depending on year and model but the zerks on mine face down and opposite of the front and back If so how do you get to them? With great difficulty Is there a zerk on the rear bearing inside left? Yes and very hard to access unless you have a contortionist grease fitting or raise the engine