Tweet
Ok guys where can i buy Axles and bearings for my Max IV ,,other than Ri, or the dealer ,,or is there other place that carry MaxIV parts (......) ''' ,OOO
-
Last edited by awesomepossum66; 03-21-2010, 04:41 PM.Max IV has a high out put heater,custom cab, windshield wiper,suspension seat,new hydraulic brakes ,cargo rack on the front ,,,and I'm loving every minute of this .
-
route 6x6 sells axles, but he just buys from recreative and marks them up. either buy from the factory, a dealer, or have them made. i would get the bearings from Motion Industries - Keeping Industry in Motion either get the numbers from your old bearings or have your dimensions when you call. motion has the best prices i've been able to find on bearings and chain. buy good bearings (fafnir)... cheap bearings are just like cheap tools... it's no cheaper if you have to buy them twice, and with bearings you get to add the aggrivation of changing them to the cost. you might also want to buy 2 axles while your at it... never a bad idea to have a spare on hand. the rate i go through them, i carry a bucket full everywhere i go (literally)
A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed. -
It all sounds good , but i dont know the number of the bearings i have ,its on a MaxIV .Max IV has a high out put heater,custom cab, windshield wiper,suspension seat,new hydraulic brakes ,cargo rack on the front ,,,and I'm loving every minute of this .Comment
-
If you will use the search feature on the site you will find a dozen or so posts on the bearings and their sizes. Here is one http://www.6x6world.com/forums/max-a...-bearings.html
Like racerone3 said in the post above yours you need to either get the numbers from your old bearings when you take them out or get the dimensions of the old bearings and call Motion Industries or Buffalo Bearings.
Edit: For the axle you should post a wanted ad in the classified section or you can contact Whipper-ag here on the site and get him to make you one.Last edited by Mike; 03-21-2010, 09:49 PM.Comment
-
route 6x6 axles where cheaper then R.I . When i had to replaced my bent axle. $170.00 axle, bearings, and shiping. R.I wanted $170.00 just for the axle.[IMG]
[/IMG]
Last edited by robertkbush; 03-21-2010, 09:59 PM.
max2 with 3000lb winch,split shifter, off road lights, and 50 amp alternatorComment
-
motion isn't bad on bearings but buffalo bearing is better and cheaper i got timken/fafnir bearings from motion outside for a max IV at my price of $25 a piece got a triple sealed bearing from buffalo bearings for $17 also get 530 atv chain NOT 50roller chain $30 from atv store for 130link1996 MAX IV ,KUBOTA DIESEL
MAX II 30HP BandoleroComment
Comment