Tweet
I have an older max IV that needs a back seat, rear floor board and engine cover . I am wondering if these parts are available and maybe an estimated price. I am also wondering if i should just make these parts. if you have a home made set up, please sent pics. THANKS!!
-
-
You can start by posting a wanted ad in the classified section of the site. Someone may have what you are looking for. You can make a floor board and seat but the rear cover would be more difficult to replicate. Since you have the front seat already you can just copy it for the rear. You can make a metal floor board. racerone3 has a how-to article on doing just that in the how-to section of the site.
As a last resort, you can purchase all of those items new as well from the factory, but I'm sure it won't be cheap.
-
In order to install a sprung tractor seat in place of the front bench seat, I made my own plywood floor. It sits atop the two inner frame channels and has two plywood rails that extend down to sit on top of the outer frame channels. I cut two square holes with a Rotozip to fit around the chain tensioners.
Pix: http://www.6x6world.com/forums/max-a...tinkering.html
It's much more comfortable. If you wanted to go this way, you could relocate your front seat to the rear.
My engine cover was a little melty near the engine when I got it, and I usually run without it because I find myself taking the darn thing off all the time anyway.Comment
Comment