Tweet
Well as some of you know I ride my Max II kinda hard at times, so I thought I would do some well over due maintenance. I started out knowing I needed at right side center axle triple sprocket. Well I decide to check all bearings inner and out, and my left side center triple sprocket. All are in need of replacing. Right all teeth were gone off the center, left side eight teeth in a row were missing. Needless to say its a good thing I am doing a complete over haul. I will be posting pictures. Starting with bearing, axles, and chains, then on to transmission and engine. I will finish up with body band and rear bumper for my max. Next up will be the same with Mel's Max and finishing up with front and rear bumper and body band.
-
-
Hope you can get it knocked out fast and go riding in July 4th at Carolina Adventure World..
-
Dan I would like to but I think I am going to have to sit this one out as much as I hate missing a ride. I still have Mel's Max II that I have to go though once I get mine done. Plus the fab work I got planned for it.Hold My B..R and Watch This!!!Comment
-
The good thing is that I have a 45 day break from any interaction from school. We'll have it done in no-time!!HUSTLEMANIAC and a HONORARY MEMBER of the
BIGFOOT ALUMNI
Comment
-
Well I have installed all inner bearing and 5 of the 6 outter bearing and flanges with new nuts, bolts, and washers. New chains are cut and ready to install just awaiting new center sprockets get here.
Last edited by CBass; 07-15-2012, 10:02 PM.Hold My B..R and Watch This!!!Comment
-
You'll be back in the mud in no time. Good to hear, give a holler when you do. Figure a weekend and lets go riding somewhere.. Durhamtown? CAW? somewhere..Comment
-
Looking good CBass i need to change all my bearings .Comment
Comment