scrambler 6x6 help

[peterjr69]

I just got a scrambler idk model but it need some of the drive parts wheel clutch disc and the I call drive pinch arm I have pic if anyone has done these please help

[thebuggyman1]

I've got bad news for you.... We see a lot of scrambler owners looking for transmission parts, and it seems no parts to be had.

Here is what another member did to save his scrambler: http://www.6x6world.com/forums/other...bler-body.html

[ARGOJIM]

Try member jerseybigfoot for parts.

[peterjr69]

im a aerospace toolmaker I have access to make anything I have to make needless to say I guess im making all new plates

[peterjr69]

where do I find seals for these? I get great deals at msc I just gotta know the type of seal

[jerseybigfoot]

They are small buna "U" cups. The problem with Scrambler hydraulics is the corrosion of the steel plungers scoring and deteriorating the aluminum bores. post some pics of the other trans parts to see if you may want to replace the trans with an older Argo gearbox with Hydraulic calipers.

[peterjr69]

the bores are spotless I tore a seal taking it off I cant find them any place

[peterjr69]

old tranny parts cleaned up and painted

[peterjr69]

got bored at work and decided I make stronger parts ahha perks of a good job

[peterjr69]

if some one has a set up that they wanna sell like argo tranny and brakes like jerseybigfoot says Im open to options... peterjr69@yahoo.com is easiest to get to me

[peterjr69]

allset I welded mine today should be fine if not I machine a new one ..

[peterjr69]

ok my clutch is stuck on the shaft I got the collars off but the clutch isn't budging come off either side? its like a go kart right slides on with a key collars on each side hold central?

[jerseybigfoot]

you will have to make a sleeve fixture to press it off with. don't press on the small end of the shaft as it will bend or mushroom. Sometimes a little heat will help. from the corrosion i see on the steering clutches its probably rusted tight.

[jerseybigfoot]

got bored at work and decided I make stronger parts ahha perks of a good job

i like the brackets"very nice" you may want to add a pair of access holes over the mounting bolts for the lower lower frame to get a socket on the bolt head. also tack the mounting bolts to underside of the lower frame.

[peterjr69]

ya I haven't gotten that far yet waiting for some 1" stock to come in to make the other end ,,,also I got hardened bushing from work to push on I have a hydraulic press tons of penetrating oil soaking on it it not budging so im up to looking for a newer axle if know of any