scrambler almost done

[peterjr69]

the steering is good the brakes work.updated a lot of the items all new u cup seals cleaned and honed cylinders no leaks real bleeders from this era,lol new clutch material all new bearings and holders motor on and ran a test clutch works great looking like it may drive again after 20 yrs.....

[amphibious drew]

That's looking great!

[Mike]

That does look great. Nice work.

[peterjr69]

ARGOJIM------------ I tired to reply but your mail box is full I used 30mm 6206-2rs I bored the id to 1.1875 the inner bearings are same an the holders I got here Manitou Mfg. Co. Two Bolt Rubber Flush Mount, Conductive Rubber Boots for Noise and Vibration Reduction

[ARGOJIM]

thanks for the info, I'll cure that.

[robeye]

Hey that looks very good.. how many hp is that motor ? I repowered a mower with a simular motor.. and I moved the key switch to a more convenient place.

[riotwarrior]

Nice very nice indeed, looks about a 14 hp engine there. Love the glass tub. I'm a glass guy from way back.

Always nice to see them clean and going together, now for it to get good and dirty with all kinds of fun LOL

Keep the pics coming and keep up the nice work.

[peterjr69]

13.5 ya I will once im done with the minor tweaks

[john swenson]

i am not familiar with that model. was curious how the steering works. thanks johnboy va.

[peterjr69]

hydraulic cylinders/pistons put or relieves pressure on opp side to turn to works off steering wheel this model