TerraTiger motor plate

[furgifab]

Hi all,
Although I've been lurking about for some time, garnering info without being a pest, I've come to the point where I could use a little help.
A few years back I acquired a TerraTiger Mod. TT-18 with what appears to be an incomplete engine swap, using a Sachs 340. Not a clue as to the original powerplant. The Sachs runs good, so I figure to run with it. However, one of the few missing pieces is the mounting plate.
I'm a decent fabricator, so making up a replacement shouldn't be a problem. If somebody has some photos of a motor mount plate/assembly it sure would make fabbing up a replacement much easier. Racerone 3 has already volunteered the owners manual PDFs, so between those and any photos available, I should be able to figure one out.
Thanks for listening...and if I have any luck with the TerraTiger project I'll post some photos of my own.
Charlie

[Amphiman1]

tiger mount

some angle iron and a plate with holes... Amphi- picts tomarro?

[racerone3]

i included a pic of the mount (best i had) in the email i sent you with the manuals

[Amphiman1]

tiger mount pict

i included a pic of the mount (best i had) in the email i sent you with the manuals

so, u think my picts suck too?

[simpleton7016]

I believe this to be an original motor mount on a TT 10 if that helps. I laid a yardstick in the pictures so that you can get some measurements.

[simpleton7016]

oh, and the height is 2 inches.

[furgifab]

Thanks for the input, gentlemen...as usual, I was over complicating things. I'm headed back to metal-torturing dungeon to see what I can come up with. If ever I come up with something worthwhile I'll post some photos.
Thanks,
Charlie