Pass Par Touts

[Joe M]

Picked up the other two, PPTs. I'll get them off the trailer today at some point and post some photos.

[Joe M]

Added a few more photos.

PPT PasseParTout - Amphibious ATV Pictures

[amphibious drew]

Very cool Joe. Have you tried to run the other 2 yet.

[Joe M]

Very cool Joe. Have you tried to run the other 2 yet.

Hi Drew,
Not yet. The engines look in better condition in the none runners. I'll play around with then over the next few days. The transmission in the runner will need going over. It doesn't want to shift, but the unit worked great for pulling the other two off the Trailer. Lot of
power.

[Joe M]

Got the engine running on the second PPT. Runs pretty good.

[Joe M]

Worked on the third PPT. Motor on this one not running. Pulled the Onan and used the CCW that Whipper gave to Brian and he gave to me. That engine runs nice. Pulled the seat, roll cage, fuel tank and engine cowling off this unit. The right steering clutch needs work. Undercarriage is in good shape. Upper body panels need work. Hat channels need replaced and a few bogie wheels need replaced.

[lewis]

Joe how about a video walk around of the vehicle. This is the first time seeing one of these machines....very nice.

[Joe M]

Joe how about a video walk around of the vehicle. This is the first time seeing one of these machines....very nice.

Okay, Lewis. I'll do a video within the next couple of days, and pm you when I post it.

[George]

Okay, Lewis. I'll do a video within the next couple of days, and pm you when I post it.

Cool! How hard is it to find parts Joe?

[Joe M]

Cool! How hard is it to find parts Joe?

George,

Some parts are still out there. I've been in contact with, Bob Cantin who was the designer and still has primary and steering clutches. Granger.com has wheels that can be used to replace the original bogie wheels. The Transmission in one of the machines is a little hard to shift, but the other two seem fine. I'm sure whipper could fix one if need be.

[Joe M]

PPT Walk Around

Well, here's the video walk around. I didn't edit it, just posted it as is. You'll see that this machine needs *A LOT* of body work!

[lewis]

Thanks for the walk around Joe. What were these machines used for?

[George]

Very cool Joe. I've seen others on Youtube but not from this P.O.V.

Thanks!

[6X6]

Very Nice Joe. I really like these machines, quite interesting beasts!

[Joe M]

Thanks for the walk around Joe. What were these machines used for?

Lewis, that ones I got were used by N.Y. Power.