Sprockets needed

[smudvapor]

I am looking for a set of Attex Thunderchief Sprockets. I need them for a racer, please let me know if you have some. Thanks.

[amphibious drew]

Probably. I will be home next weekend...I think. It's been a lot of time on the road, but I will do my best to check on parts for you then.

[smudvapor]

If you have them I can drive up.

[smudvapor]

Bump!

[smudvapor]

Still looking for sprockets!

[countrybumpkin]

If you can give me the # of teeth and the spacing from the bolt hole to the sprocket, I will see what I have.

[Mike]

If countrybumpkin doesn't have what you need, member whipper-ag can probably get/make them for you. He's done several for me.

[Don]

If you can give me the # of teeth and the spacing from the bolt hole to the sprocket, I will see what I have.

Same here. I've got a big box of used sprockets, but they all start to look the same after a while. Maybe between the two of us, Dave and I can come up with a complete set for you.

[smudvapor]

Same here. I've got a big box of used sprockets, but they all start to look the same after a while. Maybe between the two of us, Dave and I can come up with a complete set for you.

Thanks guys, I will have to go out tomorrow and measure the sprockets on my other machine because I don't have the correct ones to measure. I know the ones on my racer are 440 Thunderchief sprockets. That is what i am looking for. I will check them out and send the measurements in the morning. The sprockets are pretty much all that is left for my A stock racer. I didn't realize the sprockets that I had weren't going to work until recently.

[smudvapor]

I measured the sprockets and this is what I am getting. (Everything is in inches)
Standing in front of the machine.
Front Right 2-1/4
Middle Right 7/8 to the small sprocket and 2-3/4 to the bigger sprocket
Right Rear 1-3/4

Left Front 2-1/2
Middle Left ¾ to the small sprocket and ¾ to the bigger sprocket
Left Rear 3-3/16

The two middle sprockets are the most important, if I can find those I can make it work.
Small sprocket 20 teeth
Large sprocket 26 teeth

Thanks guys!

[countrybumpkin]

Found two centers. Silver one measures right but would need a beveled washer welded over one hole. Rusty one measures 3/4" from center of hole to side of small sprocket and 3 5/8" to side of big sprocket. I suppose you could grind the weld off the one side of the sprocket and move it over.

[smudvapor]

Found two centers. Silver one measures right but would need a beveled washer welded over one hole. Rusty one measures 3/4" from center of hole to side of small sprocket and 3 5/8" to side of big sprocket. I suppose you could grind the weld off the one side of the sprocket and move it over.

Sounds like a winner. What do you need from me?

[countrybumpkin]

With your racing discount they are free. Just pay shipping if you want them sent.

[Toys4Me]

I think I have some fronts. I'll check tomorrow afternoon. I thought I had all my old thunderchief sprockets but I could not find them. I'll check on the fronts I saw when you first posted. They are either thunderchief or superchief not sure.

[smudvapor]

With your racing discount they are free. Just pay shipping if you want them sent.

Yes, I would like them. Check your PM box.