4 Stroke engine mount plate for attex

[racerone3]

You guys are hilarious! Really need to make a Pine Lake ride and get the full experience

If I still have the coot, you are welcome to ram anything of Tom's with it. Coots don't care

[dave phelps]

Your other option is to install a performance clone single which fits easily under the original cover. Smaller,lighter more horsepower and better useable rev range.

Ok and who sells or makes these??

[Joe H]

Hey Dave, if you get it as close as race did you can just heat and reform the engine cover to fit. Put a piece if 5/8 plywood the same shape as the air cleaner lid on top of the air cleaner, close the engine cover, heat it up above the wood with a heat gun,to push down on the engine cover to get it shaped. I used some weight to hold it until it cooled. Way better than hacking apart the engine cover.

[dave phelps]

Hey Dave, if you get it as close as race did you can just heat and reform the engine cover to fit. Put a piece if 5/8 plywood the same shape as the air cleaner lid on top of the air cleaner, close the engine cover, heat it up above the wood with a heat gun,to push down on the engine cover to get it shaped. I used some weight to hold it until it cooled. Way better than hacking apart the engine cover.

Thanks Joe! I really don't want to cut up this cover so I may try it on an older one and see if I can manage it without totally destroying the darn thing!!

Thanks again!

[Toys4Me]

The unistrut will hold up just fine to 20+hp. One of the attexs has a harbor freight 22hp and no issues.

[dave phelps]

The unistrut will hold up just fine to 20+hp. One of the attexs has a harbor freight 22hp and no issues.

this a 4 chain setup your running like mine?

Thanks

[Toys4Me]

Yes all 3 attexs are 4 chains setups.

[jerseybigfoot]

Ok and who sells or makes these??

Bullfrog Motorsport, Vegas carts.
Bullfrog can build one with a charging system and electric start.

[Toys4Me]

The first one I made with just scraps laying around.

[dave phelps]

The first one I made with just scraps laying around.

Thanks for all your inpuy on this! I've got to get busy and get this project going...

Dave Phelps