MAX II engine cover

[buck0123]

Looking for a engine cover for a MAX II.

[wedge]

What Year ?
Is it the Flat plate or the Hump cover ??

[buck0123]

hump cover.

[racerone3]

again, what year/ what engine. Hump cover to go over a modern briggs/ kohler machine, or the small one to go over the valve cover on an older Tecumseh equipped machine?

[wedge]

No Problem
If your not sure on the year give us the Searieal # on the plate on the dash.
Or easyer yet if it has a Briggs 14 to 18 engine in it ?
Someone here will be able to hook you up !
Good luck and when you can Post pics of your ride !

[buck0123]

1984 max II 440 2 stroke.
engine swap to 14hp briggs vangaurd

[wedge]

OK Now we are in the park !
So you may need to FIT a newer cover to it ?
Can you up load a pic so we can see what your working with ?

[buck0123]

basically I will cut my upper body that had the small flat plate to fit the new engine cover. I don't have any pics machine is still apart, bare frame is on a table getting inner axel bearings installed and frame painted.

[wedge]

Well at this point if you can't find a factory Hump cover I would make a Top filler cover unless you want the tube carrying section.?
Some guys run with out them to let the heat build up out and I have seen some cut the whole floor out and make a top cover so it was easy to get at the engine and drive . It's all in what you want in the end product ?

[Leftybowler22]

I sent you a PM if you still need a cover.