Tweet
Looking for a 1 1/8 bore secondary clutch. does net even need to be functional. all I really need is the 2 sheaves. basically trying to make a large pulley to go on a kohler engine to run a 1 1/2 top width belt. I have some 1" argo clutches but there isn't enough meat to bore them out
-
A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed. -
Polaris?sigpic
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs. -
blew the engine in my old bobcat. swapping in a 25hp kohler that I have on the shelf. trying to make a fixed pulley to go in place of the variable speed on the old WisconsinOriginally posted by ARGOJIM View PostA well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.Comment
-
Do you need primary or secondary?
What was in it before?sigpic
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs.Comment
-
Secondary. The bobcat had a hydraulically controlled primary. I am just trying to make a fixed pulley to limp it along. I can't find the shaft size of the Wisconsin anywhere and won't know till I tear it down next week.A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.Comment
Comment