King Midget restoration

[Andyman]

Looking like new again

Nice work

[JoeMeg]

Lookin' good Nubs

[Nubs]

Bodywork finely done, Metallic blue they picked. I'm ready for this to be done.. sand, sand, sand, primer, sand, seal bla bla.......

Thanks for the Nice posts

[Andyman]

I feel for you on the sanding thing, I am fixing up a `67 Dodge Dart and am at that point now too.


You have done an excellent job on that one, before your sore arms heal up come help me !!!!!!

[Nubs]

I feel for you on the sanding thing, I am fixing up a `67 Dodge Dart and am at that point now too.


You have done an excellent job on that one, before your sore arms heal up come help me !!!!!!

Thanks, block sanding is the only way get em' flat, I'd give a rotator cuff to spend a week er two out your way.

been a lot of yrs

[OffRoadney]

this is impressive! is this finished or do you have other planned mods for it?

[Nubs]

Thanks for lookin, Not done yet. I'm in the middle building new hubs and brake drums so we can install aluminum rims similar to this car.



thinkin' the roll bar would be a good add on also, gonna post more pics in a few days

[Andyman]

Looks fantastic !!

[Nubs]

just to be clear, that is not the car i'm workin on in that picture. just usin the picture as my inspiration'ish

[Andyman]

Well dangit... still looks fantastic

[Nubs]

the one piece hub/wheel/drums were shot so dug up some stock layin' around and made up new ones. the thick walled pipe was a little over kill but it was free went with spacer adapters so one can switch up wheel combos. had these off of another project so we used them

[Andyman]

Handy man you are Nubs

[Andyman]

Did you see this Nubs?
The King Midget makes a return, sort of, for its 70th anniversary | Hemmings Daily

[Nubs]

Thats cool hey, I moved into a bigger shop this spring and just finishing up a homemade paint booth. the midget is on the table waitin' to roll in, It kinda got pushed back in the corner...
Ya know how that goes