Tweet
What size bolt do I need to make a puller for my 295 JLO / Salisbury clutch? It looks to be about 22mm x 1.75 thread. That is not a common bolt size. A piece of 1/2" pipe almost fits. The pipe is a little small.
-
-
Hey Lance, I don't think there is a standard size. Each one I have pulled has been different. I can bring my collection to Haspin if you can wait that long, but no guarantee I'll have the right one. -
Think most 2 stoke salisbury's are 9/16 fine thread, a 3/8 r/s cut to the right length and set in the bolt should work.sigpic
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs.Comment
-
Much bigger than 9/16. I have one and its way too small. I also have another adapter sleeve for the 9/16 and its too small.Comment
-
ok sorry Lance, the 700 series I pulled off my 300 and the 910 I pulled off the Chapparal were both the 9/16 threaded ones.sigpic
My new beer holder spilled some on the trails - in it's hair and down it's throat.
Joe Camel never does that.
Advice is free, it's the application that costs.Comment
Comment