What do you guys think this is worth?

[green]

Got this on a deal today. Was told it runs great. I have no clue. I know it wont work for our application (6x6) because the output shaft is too large. It's 1 1/8th. So, I'm going to try and sell or trade it for one that will work. I just have no clue what it would be worth.

http://i.imgur.com/Tf7UHE0.jpg
http://i.imgur.com/XCkihiT.jpg
http://i.imgur.com/jVg5pJj.jpg
http://i.imgur.com/X9HqgId.jpg

[phabib]

It looks like a Kohler Magnum series engine. You could get an inch and an eighth clutch for it if you wanted to.

[green]

Ha, where at?

[wfo]

75 bucks
roy at quality drive systems

[green]

Well, here's my next question (don't anybody laugh too much) Can someone send me detailed instructions on how I can start this engine on the bench? I have no clue. If you don't want to use the forum space you could send it to my email charles.green3@yahoo.com

Thanks

[ARGOJIM]

To safely bench start the engine, bolt 2 bolts from engine to bench, hook up a ground cable to engine from battery, hook starter solenoid up and wire in a starter button to small terminal on solenoid, wire on/off switch to positive side of the coil, engine should start and run unless it has a fuel shut off solenoid on carb.