ATTEX ST 400 Carburator

[Ghost63]

On to the engine now, I'd like to replace the Carburator on this JLO400 but I cant seem to figure out what I need. I know Im gonna need a Flange Mount adapter, with 57mm spacing, center to center, and have found the Mikuni # 990-842-046 that appears to be correct size.
I'm looking at the Mikuni VM30-83, does anyone know if this will fit that adapter? Or does anyone have another setup they have done with the ST400 2 stroke Twin Cylinder?
Thanks in advance for all your help.

[dave phelps]

I looked on EBay and I think it needs to be 60 mm spacing for that carb. Look under mikuni vm 30 carb flange and see what you think.
Good luck with it!!
Btw. I hunt over in rushville.good people over there!!

[Don]

If memory serves me, the ST400 was equipped with a flange-mount 28mm round slide mikuni. If you can find a rubber snorkel mount and standard 30, 32, or 34mm round slide you will most likely be better off, especially in the summer. I'd be willing to bet you could find both on ebay, but I haven't looked. Good luck!

[johnedwardketch]

call richard at route 6x6 hell guide ya right if you can get mike his mechanic on the phone hell nail it that guy knows''' everthing there is on atvs all makes models