Announcement

Collapse
No announcement yet.

Whats a running 25hp Kohler horizontal engine worth?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tomo
    replied
    HI ,
    The KOHLER 25 hp SMALL BLOCK
    obtain model and serial
    start with ch25s [command, horizontal crank 25 hp electric start ]
    18--thru to 28 hp have a chequered past
    the rectifications include
    different valve cover bolts
    valve cover gasket upgrade
    PCV [crank case ventilation ] gasket upgrade
    Pcv upgraded vent hose
    cylinder head upgrade
    head bolt to stud conversion
    3- 4 different inlet manifolds manifolds leak air/vacumn
    DELCO REMY str motor is now used - mowing pushes debris into starterand wears them quickly

    points of note
    blown cylinder head gaskets are a problem not so much these days but still happens
    Early units in 25 hp and 26 hp efi had a nikisil bores . The bores delaminate[coating falls off ]
    They are not cast iron and cannot be bored Re sleeve but $
    The valve rocker bolt pulls out of the cylinder head when old. Helicoils do not fix this Screw in steel plug and dowel in position
    Mechanical fuel pump on rocker cover can fall apart filling sump with fuel
    Original camshaft is very soft and wears out quickly
    There are different hydraulic lifters now as some were extemely bad /noisey

    The 20 hp is the best engine and has proven reliable
    all cast bores
    engine does not run at the temperature limit say 200- 212f 25hp 212 --240 f

    The oil cooler on the 25 hp is only good for say 5 deg f
    Experience same cooler brand but 11 x8 1 1/2 thick cools 30 deg f [10 inch fan ]

    VERY IMPORTANT
    If from a mower application some have cleanout plates on the flywheel end plastic cover gold or black colour . These are to blow out cylinder head fins remove air debris grass etc
    REMOVE FLYWHEEL AND CLEAN GRASS OUT

    tomo
    Last edited by Tomo; 01-25-2010, 02:42 AM.

    Leave a comment:


  • argohunter
    replied
    That oil cooler would be nice to have.

    Leave a comment:


  • LarryW
    replied
    Im sure you guys know but just incase. Its not impossible but finding a clutch to fit is harder with that size crank.

    Leave a comment:


  • thebuggyman1
    replied
    Sounds like you found a source with many of these. If there are extras I may be interested in one.
    Thanks.

    Leave a comment:


  • PlumCrazy
    replied
    Originally posted by PlumCrazy View Post
    Whats a running 25hp Kohler horizontal engine worth?
    I was looking for a 4cycle for one of the Superchiefs, thought these might fill the bill.
    They are out of a zero turn mower.
    I will pass alone more info, just as soon as I get it.

    They have 1-1/8" output shafts.
    Pic of engine.
    Last edited by PlumCrazy; 01-24-2010, 08:38 PM.

    Leave a comment:


  • racerone3
    replied
    Originally posted by PlumCrazy View Post
    Whats a running 25hp Kohler horizontal engine worth?
    absolutly nothing... send it my way, i'll pay shipping

    Leave a comment:


  • argohunter
    replied
    Hard to say P/C. All engines are not created equal so it helps to have more information on the engine your asking about. There should be a sticker on the engine listing model#, series#, specification# etc.

    Command, Command Pro, something else ?

    EFI or carb?

    What application is it out of?

    Leave a comment:


  • Whats a running 25hp Kohler horizontal engine worth?

    Whats a running 25hp Kohler horizontal engine worth?
Working...
X