Tweet
Oil cooler install
is there a way to install an oil cooler on a Briggs and Stratton 18HP Vanguard V-twin commercial that has an oil filter on it? if so can anyone post up a pic of how its hooked to the engine
-
is there a way to install an oil cooler on a Briggs and Stratton 18HP Vanguard V-twin commercial that has an oil filter on it? if so can anyone post up a pic of how its hooked to the engine
sigpic1969 Gip-Sea four stroke conversion 1983 honda Big Red 200E engine
1969 ATTEX ST/300/D four stroke conversion 18HP vanguard V-twin
-
Hey Duke, I still have the oil cooler adapter that I took off that engine when I put the oil filter on it. Give me a call.
REB -
cool I didnt know it had one on it before sorry if you told me my memory is terrible or all of my attention was on the 6x6
I will have to call you tomorrow or something. also I was told you sent me another PM but I didnt get it
sigpic1969 Gip-Sea four stroke conversion 1983 honda Big Red 200E engine
1969 ATTEX ST/300/D four stroke conversion 18HP vanguard V-twinComment
-
ok I am going to get the oil cooler adapter from REB my next question is I am going to mount my oil cooler on the back of my roll cage (inside it of course) will I need a backflow valve of some sort or is the oil pump on the engine going to hold it so it doesnt drain into the engine?sigpic1969 Gip-Sea four stroke conversion 1983 honda Big Red 200E engine
1969 ATTEX ST/300/D four stroke conversion 18HP vanguard V-twinComment
Comment