Attex throttle cable

[rocketman17joe]

I found the perfect replacement throtle cable ,order a max 4 cable with lever for a kawaski engine.its the perfect lenghth you must petap the carb lid and cut off the excess

[jpswift1]

I've been doing this for a while on machines with Mikuni carbs. You can use whatever length you need, Max IV, Max II, Buffalo Truck, along with the Max throttle handle. Then drill the Mikuni carb cap with a "letter I" drill bit. Next you tap it with a 5/16" 20 or 24 pitch I believe, tap. You also might need to cut a little bit of the metal end down so it fits in the round slide of the carb. Then just assemble it and you're good to go.

[rocketman17joe]

now i do have a question,i bought a maxII cable and it was to short I returned it and gat a max4 and it fit.How did you get the MaxII to fit?? Oh i have a 400 chief with a jlo

[jpswift1]

now i do have a question,i bought a maxII cable and it was to short I returned it and gat a max4 and it fit.How did you get the MaxII to fit?? Oh i have a 400 chief with a jlo

I used a Max IV throttle cable too for my 440 Thunderchief racer and on my Superchief trail machine with a Kohler V twin I used a Max II cable because it's routed differently. I mentioned in my previous post, you can use whatever one length you need......this all depends on the application. I do a lot of custom work and use different lengths for every machine I build. You just have to get your measurments first.