3 bolt pattern hubs?

[allwheeldrive]

While most are looking to convert the old 3 bolt pattern hubs to 4 bolt etc. I'm actually in the middle of building a project that utilizes my old 3 bolt balloon tires. However I'm not sure the best solution to mount them up to an axle.

The project is a light duty machine running on 5/8 keyed axles (maybe 3/4" if that's a hub size I can find)

Any ideas?

[liflod]

http://www.6x6world.com/forums/conte...e-adapter.html

[allwheeldrive]

I was looking at those liflod thinking about machining my own. The trouble is a set of 4 likely cost more than the entire project. The problem stemming from having to cut a key way into the hub. I was thinking buying some small keyed sprockets than drilling out the 3 hole pattern might be the cheapest solution. Unless someone knows where these could be are still sold. Maybe for a different application.

[liflod]

Go to Surpluscenter.com.
Look at the weld on sprocket hubs.
Tractor supply sells them also.

[ARGOJIM]

Find some from an amphicat