Announcement

Collapse
No announcement yet.

T/20 drive pulley ?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    T/20 drive pulley ?

    Pulled the pulley off and was wondering what the torque is on the bolt
    Basically the pulley doesn't want to go all the
    Way on scared of breaking the bolt already cleaned it and installed anti seize it's out of alignment by about 3/8 of an inch
    Any ideas or help would
    Appreciated

    Mike
    Tags: None
  • #2
    The clutches should be off set a tad, perhaps thebuggyman will post the picture from the manual I couldn't find.
    sigpic

    My new beer holder spilled some on the trails - in it's hair and down it's throat.
    Joe Camel never does that.

    Advice is free, it's the application that costs.

    Comment

    • #3
      Is this the one you mean Jim?
      [IMG][/IMG]

      I believe the bolt is a fine thread 3/8" grade 8.....I don't know the torque spec, but would suspect 20-25 ft/lbs, no more. I don't think it would ever loosen up at 15 ft/lbs. I rarely use a torque wrench (bad, bad habit), just by feel.

      Comment

      • #4
        That's it Jim, if that's what he is stating is the problem of being out of alignment.
        sigpic

        My new beer holder spilled some on the trails - in it's hair and down it's throat.
        Joe Camel never does that.

        Advice is free, it's the application that costs.

        Comment

        • #5
          Thank you so much does it say what the offset should be ?

          Comment

          Previous template Next
          Working...
          X