Tweet
Say hey
I've got a 2010 8X8 HDI and need to remove the right side output shaft to change the collar on the spline as the left side collar striped and has been replaced. I've backed off the speedo magnet contact but can not get the shaft to clear the trans shaft. The inner bearing seal will not clear the bolts against the frame. The left side was replaced without much difficulty. Looking for any tips.
Tks
DC
I've got a 2010 8X8 HDI and need to remove the right side output shaft to change the collar on the spline as the left side collar striped and has been replaced. I've backed off the speedo magnet contact but can not get the shaft to clear the trans shaft. The inner bearing seal will not clear the bolts against the frame. The left side was replaced without much difficulty. Looking for any tips.
Tks
DC
Comment