Belt Size: How to determine Proper Belt size needed?

[mustangwagz]

Hey guys, need to determine HOW to order the correct belt. Width will be 1.25, got that figured out already. (i is smart! ) but now i need to determine my length. Ive got motor where i want it and i still need to "add-on" to the mount to make it a tad bit longer to fully support the vtwin, however, this shouldnt affect it very badly.

So..i was reading about Quality Drive Systems (and a guy named ron) from a different post on here. Should i just call him and let him do the math for me? or is there a way to figure it all out on my own? Let me know gents!

-WagZ-

[gearhead1937]

Hope this helps...

http://www.6x6world.com/forums/trans...-question.html

[micmac]

If you have your old belt you can cut it and use it to measure up the difference

[mustangwagz]

Holy crap...i was readin last post in the belt question thread, clicked the calculator link, looked at the math equations and gave my self an anurism...holy ****, i need to go write crap down. lol..this SUCKS! i HATE MATH!...and it hates me too!