[tracmaster]

Probably a good idea...I think if the banjo fitting was turned 180 degrees it would be ok...or just order one of the other longer lines and just put a loop in it...on another note...I thought you might be inerested in 2 simple modes I made..1 is to disconnect the start in neural wire on harness and rewire it to a small green led light on dash so when your out of gear it will light..#2 ..remove the grill under the hood scoop an recut to fit the cutouts in the hood...pop rivets with washers on the inside work well....also I bought 2 extra rubber mouldings from odg (used for the rear end of the tub) and put them at entry point for passenger and driver...this gives your hdi a finished look and you won't have to clean that area from leaves and branches..one other thing I did was ordered ARP stainless 6 sided bolts from summit racing and replaced the handrail and seat backrest screws..