Tweet
Hi buggyman,
Hope your year is going good so far. I got a question, I remember you showing me your frames for the maxII, and you mentioned about reinforcing it and showed a pic of one done. I have been un-able to find anything on the site about how to for the maxII, only the maxIV. Will the diagram for the IV work on the II, and if not can you tell me where you put the reinforcements at ( measurements, etc) and what did you use.
Also I am looking at a Kawasaki 25 hp (FH721D) for $500 off a JD ZTrac, that is due for a rebuild. It is a side shaft model, not much mentioned on the site about this also, what is your opinion of that motor going in a Max IV or Max II, just looked up all the specs, and appears to be able to put most AATV through tough play.
Hope your year is going good so far. I got a question, I remember you showing me your frames for the maxII, and you mentioned about reinforcing it and showed a pic of one done. I have been un-able to find anything on the site about how to for the maxII, only the maxIV. Will the diagram for the IV work on the II, and if not can you tell me where you put the reinforcements at ( measurements, etc) and what did you use.
Also I am looking at a Kawasaki 25 hp (FH721D) for $500 off a JD ZTrac, that is due for a rebuild. It is a side shaft model, not much mentioned on the site about this also, what is your opinion of that motor going in a Max IV or Max II, just looked up all the specs, and appears to be able to put most AATV through tough play.