Forum: Engines

Ok, I have a 2005 Max IV with a 20hp Kholar Magnum Model M205 engine. I ran it last year without a problem during hunting season. I decided to sell...

I'm looking for a good used carb for my stock JLO 440 if anyone has one for sell. I have the stock carb and I think it is a 30mm or 32mm flange...

Since my motor is locked up is there any parts i should remove and possibly sell before trashing it ?

When in nuetral, when I release the throtle it back fires through the exhaust. I do have a fuel smell, I thinking I'm running rich and need to lean...

Man I have a problem with a 23 hp v-twin vanguard. It is surging at idle and I had changed fuel filter and plugs when i took off air cleaner it seems...

Ok guys, here is the build to deal with how to adapt a snow machine clutch to the flex plate. You will need 1. a good machinest machinest 2....

:hmmmm2: I've been working with this machine for the past year. Last season we used it pretty hard and had no issues. This season I've been having...

Hey guys. I am trying to better understand the role of the rectifier and see if it is possible to upgrade due to the increased lighting I am...

i got a jlo that seems to have spark then looses it then comes back. anyone know what it might be loose wire points not adjusted right. its in a...

I recently acquired a 1972 Attex Crazy Colt it had been sitting around 4 a while, I drained the gas and wired it up. A couple of days ago it would...

I'm wondering how many watts or amps I can continuously draw from my Argo/Kohler lighting coil. I was thinking to add some extra lights n such.

Hey guys. I had a Walbro carb on my 440 Thunderchief. Didn't run so good. When it started it ran great, it just didn't want to restart after I...

I have a 16 hp in my max 2, it had been running great, yesterday I backed it up on a steep bank and and back down. After that it wouldn't start...

Hello Everyone, I've got a 1997 Bigfoot that seems to have a fuel starvation problem only going up forwards on steep inclines. It did it with my...

Looking for ideas or proven plans on fitting the B&S on the motor plate of my Max IV. Bolt pattern is different, B&S is much wider than the Kawi. ...

Okay, here is the story. At the last race (last month) I rolled my machine over. Before that it ran fine. When I went out for the next race I got...

I have a Kohler Command 18. I need Crank seals for it and V,cover gaskets. Where is the best place to get these ? Thanks Guys! Tj

Hi All I have a issue with my 18hp Vanguard and I will try my best to put all info in the post. 1. year 2000 vanguard 18hp 2. year 2000 max II 3....